We use cookies and your data to present the best experience visiting our web site. To continue navigation on this web site, you accept that your data are collected.

When Should I Consider Installing my Press on Spring Isolators?

When Should I Consider Installing my Press on Spring Isolators?

For a majority of stamping press installations, Vibro/Dynamics elastomer isolators provide the best combination of vibration control, machine stability, ease of installation, and precision leveling. However, there are certain situations when installing a press on spring-type isolators would be a good or even the best choice. This article is intended to help you determine whether your press installation might be a good candidate for spring isolators.

What’s the difference? – It’s important to understand the basic difference in performance between the spring and elastomer-type isolators. In a nutshell, while elastomer isolators provide excellent vibration control, spring-type isolators provide even greater vibration reduction. The trade-off is that spring isolators allow greater press motion, thus elastomer isolators are typically used to provide stability where maximum vibration reduction is not required. There is also often a difference in the size of isolator used for the same load. Since elastomer isolators generally support a larger load in a smaller area, spring isolators are typically physically larger for the same size press. Finally, grout plates are typically recommended under spring isolators, while elastomer isolators are installed directly on the concrete surface.

Environmental Issues – Whenever a press is installed in an environment where maximum vibration reduction is important due to an existing or potential vibration problem, then the press should be analyzed to see if it can be installed on spring isolators. Examples include presses installed near residential or business neighbors, near sensitive machinery, or near office spaces. In most of these cases, installing a press on spring isolators allows the press to run in closer proximity to both people and other machines so it doesn’t have to be relocated or limited in its production.

Press Design and Operation – The design of the press and the operation being run also play a key part in determining whether spring isolators are a good option. Large (400-ton capacity and larger) presses with counter-rotating eccentric drives are often good candidates. These larger presses (and their surroundings) generally benefit from the additional vibration control, yet are balanced enough not to move too much on spring isolators.  On the other end of the spectrum, dynamically-balanced, high-speed presses (greater than 300 SPM) hum along nicely on spring isolators and you should definitely consider them if you have such an installation.

Personal Preference – Some metal stampers simply prefer to install presses on spring isolators because they have done so before or want the maximum amount of vibration reduction and are comfortable with a few millimeters of press movement. The use of coil spring isolators is also more common outside the U.S. These users have come to expect the level of vibration isolation provided by spring isolators as well as the press motion they allow.

Whatever type of press you have, Vibro/Dynamics will analyze your specific installation and offer the options which are best for your press, whether that be elastomer and/or spring isolators.